| SenDEC surface mounted, inductive input meters are available in models designed to monitor all types of gasoline-powered engines. These hour meters, with optional tachometer functionality, are also available with SenDEC Flash Alert™ that flashes required maintenance at preset intervals. Epoxy encapsulation protects this meter from shock and vibration and seals out the harshest environments. The self-contained power source ensures continuous display of total run hours or RPM. Installation is quick and easy - simply wrap the pickup wire around the outside of the spark plug wire. Strong pick up reception lets you locate the meter 8 feet (or more) away from the source.
Function Specifications
Hour Meter
- Records and displays to: 9,999.9 hrs
- Hour glass symbol appears and flashes on/off to indicate counting time
- Automatic roll over
- Resolution: 0.1 hour
- Quartz accuracy: +/- 0.02% (over entire voltage & temperature range)
Tachometers
- Resolution: 10 RPMs
- Maximum RPMs: 7000 (except for Model 806-100-2012, which has a 4,300 rpm max)
- Suitable for most single and twin, four cycle gasoline engines operating within specified tachometer firing pattern (except Kohler Command engines using Smart-Spark ignition)
Flash Alerts
- Two service alarms with one-time break-in interval
- Key KancelSM (Flash Alert is latching; reset by using a SenDEC reset wand)
- "CHG Oil" message
- "LUBE" message
- "CHG Muff" message
- "SVC AIR FILTER" message
- Two "SVC generic messages
- Custom messages available for OEMs
Environmental Specifications
- Operating temperature: -40F to 160F, -40C to 71C
- Shock: SAE J1378 55g's
- Vibration: SAE J1378 20g's
- Humidity: SAE J1378 95% RH
- 100% Epoxy encapsulated
- LCD digit height: 0.200
- Case material: ABS, black
- Weight: 1 oz
Installation
All dimensions in inches. To print figures individually, right-click on the image and save to your local computer.
- Find a convenient mounting location. Make sure the pick-up wire will reach the spark plug wire. If not, substitute with a wire of the same outside diameter of no less than 22 gauge, up to 8 feet long. DO NOT mount meter where surface temperature exceeds 125 F. As a general guideline, if you can place your hand on the mounting surface without discomfort while equipment is at full operating temperature, it is okay to mount the meter there.
- Use drill template (Fig. 1) to locate mounting holes.
CAUTION: DO NOT DRILL INTO GAS TANKS OR ENGINE CRANKCASE. If in doubt, contact your dealer.
FIG. 1 Back Side of Meter
2.125" L x 1.490" W x 0.550" D
- Secure pick-up wire to meter by placing wire over channel and pressing down with a flat screwdriver. Wire must be seated completely in channel (see Fig. 2). Fasten meter to mounting surface with supplied screws. Route wire to spark plug wire and attach as shown in Figure 3.
|
